Gasoline injection and ignition system (ME-SFI) diagnosis - diagnostic trouble code memory (Fault Codes P0305, P0306, P0307, P0308, P0325, P0330, P0335, P0341, P0370, P0400, P0410, P0422, P0432, P0440, P0441, P0442, P0443, P0446, P0450, P0455, P0460, P0500, P0507, P0520, P0560, P0565, P0600, P0604, P0605, P0700, P0702, P0715, P0720, P0730, P0740, P0743) - AD07.61-P-4000BA
ENGINES 113.940 /942 /943 up to 31.5.00,
113.961
Fault codes from P0305 to P0743
| Hazard from contact with parts conducting high voltages. | Do not touch parts which conduct high voltages. Persons who wear electronic implants (e.g. heart pacemakers) must not carry out work on the ignition system. | AS15.10-Z-0001-01A | |
| Lethal hazard from being drawn into rotating vehicle parts | Do not reach into rotating parts. Wear closed and close-fitting work clothes. Secure area of rotating vehicle components against unauthorized access. |
AS00.00-Z-0004-01A | |
| Risk of explosion from fuel igniting, risk of poisoning from inhaling and swallowing fuel as well as risk of injury to eyes and skin from contact with fuel. | No fire, sparks, naked flames or smoking. Pour fuels only into suitable and appropriately marked containers. Wear protective clothing when handling fuel. |
AS47.00-Z-0001-01A | |
| Notes on avoiding damage to the ignition system | Engines 104, 111, 112, 113, 119, 120 with ME-SFI fuel injection and ignition system | AH15.10-P-0002-01D | |
| The fault code cannot be read out with the pulse counter | |||
| ■ Symbol for USA vehicles for activation of the malfunction indicator lamp CHECK ENGINE • Symbol for EURO3 vehicles for activation of the engine diagnosis malfunction indicator lamp (is indicated in the HHT as ■) The malfunction indicator lamp does not go on until a fault relevant for the exhaust system was stored during the last driving cycle (exception misfire "damaging to TWC", malfunction indicator lamp goes on immediately). |
|||
| Ignition: On | |||
| Connect hand-held-tester (HHT), read out diagnostic trouble code memory | AD00.00-P-2000-03A | ||
| Gasoline injection and ignition system (ME-SFI) diagnosis - prerequisites | AD07.61-P-2000B | ||
| Check and adjust engine | Engine diagnosis manual | ||
| Diagnostic trouble code memory | |||
| Fault code |
Possible cause | Note | Remedy |
| No fault code | No fault detected | Depending on the complaint, carry out testing of ME-SFI electrical system in full | AD07.61-P-6000B AD07.61-P-6001B AD07.61-P-6002B AD07.61-P-6003B |
| P0305 ■ • | A Misfire in cylinder 5 B Misfire in cylinder 5 "damaging to TWC" |
AD07.61-P-6001-15B AD07.61-P-6001-17B AD07.61-P-7002-01A AD07.61-P-7002-01B Compression pressure |
|
| Fault code description for misfires, ME-SFI | AD07.61-P-4000-11B | ||
| P0306 ■ • | A Misfire in cylinder 6 B Misfire in cylinder 6 "damaging to TWC" |
AD07.61-P-6001-16B AD07.61-P-6001-17B AD07.61-P-7002-01A AD07.61-P-7002-01B Compression pressure |
|
| Fault code description for misfires, ME-SFI | AD07.61-P-4000-11B | ||
| P0307 ■ • | A Misfire in cylinder 7 B Misfire in cylinder 7 "damaging to TWC" |
AD07.61-P-6001-20A AD07.61-P-6001-17B AD07.61-P-7002-01A AD07.61-P-7002-01B Compression pressure |
|
| Fault code description for misfires, ME-SFI | AD07.61-P-4000-11B | ||
| P0308 ■ • | A Misfire in cylinder 8 B Misfire in cylinder 8 "damaging to TWC" |
AD07.61-P-6001-21A AD07.61-P-6001-17B AD07.61-P-7002-01A AD07.61-P-7002-01B Compression pressure |
|
| Fault code description for misfires, ME-SFI | AD07.61-P-4000-11B | ||
| P0325 | Knock sensor on right | Connector line Knock sensor |
|
| Fault code description for knock sensor, ME-SFI | AD07.61-P-4000-12A | ||
| P0330 | Knock sensor on left | Connector line Knock sensor |
|
| Fault code description for knock sensor, ME-SFI | AD07.61-P-4000-12A | ||
| P0335 | Crankshaft position sensor (L5) | AD07.61-P-6001-09B | |
| Fault code description for crankshaft position sensor, ME-SFI | AD07.61-P-4000-13A | ||
| P0341 ■ • | Camshaft Hall sensor (B6/1) | AD07.61-P-6001-10B | |
| Fault code description for camshaft Hall sensor, ME-SFI | AD07.61-P-4000-14A | ||
| P0370 | Angle deviation for camshaft to crankshaft | Check basic adjustment of camshafts | |
| P0400 ■ | Exhaust gas recirculation malfunction (causal chain) | AD07.61-P-6000-27B | |
| Fault code description for exhaust gas recirculation malfunction (causal chain), ME-SFI | AD07.61-P-4000-50B | ||
| P0410 ■ • | Secondary air injection malfunction (causal chain) | AD07.61-P-6000-24B | |
| AD07.61-P-6000-25A | |||
| AD07.61-P-6000-26A | |||
| Fault code description for secondary air injection malfunction (causal chain), ME-SFI | AD07.61-P-4000-15A | ||
| P0422 ■ • | Effect of right three-way catalytic converter too low | Right three-way catalytic converter | |
| Fault code description for three-way catalytic converter effect too low, ME-SFI | AD07.61-P-4000-16B | ||
| P0432 ■ • | Effect of left three-way catalytic converter too low | Left three-way catalytic converter | |
| Fault code description for three-way catalytic converter effect too low, ME-SFI | AD07.61-P-4000-16B | ||
| P0440 ■ | Purge system leak (causal chain) | AD07.61-P-6000-30A | |
| AD07.61-P-6000-31A | |||
| Fault code description for purge system leak (causal chain), ME-SFI | AD07.61-P-4000-17A | ||
| P0441 ■ | Purge control valve (Y58/1) | AD07.61-P-6000-29A | |
| Function | AD07.61-P-6000-30A | ||
| Fault code description for purge system leak (causal chain), ME-SFI | AD07.61-P-4000-17A | ||
| P0442 ■ | Purge system slight leak | AD07.61-P-6000-31A | |
| Fault code description for purge system leak (causal chain), ME-SFI | AD07.61-P-4000-17A | ||
| P0443 ■ • | Purge control valve (Y58/1) | AD07.61-P-6000-29A | |
| Fault code description for purge control valve, ME-SFI | AD07.61-P-4000-19A | ||
| P0446 ■ | A Activated charcoal canister shutoff valve (causal chain) | AD07.61-P-6000-32A | |
| B Activated charcoal canister shutoff valve (Y58/4) | AD07.61-P-6000-33A | ||
| Fault code description for activated charcoal canister shutoff valve, ME-SFI | AD07.61-P-4000-20A | ||
| P0450 ■ | A Tank pressure sensor (B4/3) electrical fault B Tank pressure sensor (B4/3) electrical vibrations |
AD07.61-P-6000-33A Activated charcoal canister blocked |
|
| Fault code description for tank pressure sensor, ME-SFI | AD07.61-P-4000-21A | ||
| P0455 ■ | Purge system with severe leak or voltage supply for tank pressure sensor (B4/3) | AD07.61-P-6000-31A | |
| AD07.61-P-6000-33A | |||
| Fault code description for purge system leak (causal chain), ME-SFI | AD07.61-P-4000-17A | ||
| P0460 | Fuel level gage sensor | Read out IC | |
| Fault code description for misfires, ME-SFI | AD07.61-P-4000-11B | ||
| P0500 | A front left vehicle speed signal B rear left vehicle speed signal |
Check ASR in chassis diagnosis manual, index 9 AD42.45-P-1000AZ |
|
| Fault code description for vehicle speed signal, ME-SFI | AD07.61-P-4000-23A | ||
| P0507 | Idle speed control implausible | AD07.61-P-6002-01C AD07.61-P-6002-01D AD07.61-P-6002-03A |
|
| Fault code description for idle speed control, ME-SFI | AD07.61-P-4000-24A | ||
| P0520 | Oil pressure sensor for cylinder cut-out system | CODE (479) for cylinder cut-out system | refer to STAR DIAGNOSIS |
| Fault code description for oil pressure sensor for cylinder cut-out system, ME-SFI | AD07.61-P-4000-58B | ||
| P0560 | Voltage supply to ME-SFI control module (N3/10) | AD07.61-P-6000-01B | |
| AD07.61-P-6000-02B | |||
| Fault code description for control module voltage supply, ME-SFI | AD07.61-P-4000-59A | ||
| P0565 | Pushbutton switch for variable cruise control (S40/4) | AD07.61-P-6003-01E | |
| P0600 | CAN of ESP | AD07.61-P-6000-34A | |
| Fault code description for CAN damaged, ME-SFI | AD07.61-P-4000-26A | ||
| P0604 | A ME-SFI control module (N3/10) B ME-SFI control module (N3/10) |
N3/10 | |
| P0605 | ME-SFI control module (N3/10) | N3/10 | |
| P0700 ■ | Read out diagnostic trouble code memory for ETC control module (N15/3) | AD27.19-P-6000A | |
| Fault code description for gear implausible or transmission with leaks, ME-SFI | AD07.61-P-4000-27A | ||
| Fault code description for command valve sticks in pressure position, ME-SFI | AD07.61-P-4000-28A | ||
| P0702 ■ | Read out diagnostic trouble code memory for ETC control module (N15/3) | AD27.19-P-6000A | |
| Fault code description for ETC control module, ME-SFI | AD07.61-P-4000-29A | ||
| Fault code description for valve supply voltage, ME-SFI | AD07.61-P-4000-30A | ||
| P0715 ■ | Read out diagnostic trouble code memory for ETC control module (N15/3) | AD27.19-P-6000A | |
| Fault code description for supply voltage and function of RPM sensors, ME-SFI | AD07.61-P-4000-31A | ||
| P0720 ■ | Read out diagnostic trouble code memory for ETC control module (N15/3) | AD27.19-P-6000A | |
| Fault code description for CAN fault identification, ME-SFI | AD07.61-P-4000-32A | ||
| P0730 ■ | Read out diagnostic trouble code memory for ETC control module (N15/3) | AD27.19-P-6000A | |
| Fault code description for gear comparison (multiple times) negative, ME-SFI | AD07.61-P-4000-33A | ||
| P0740 ■ | Read out diagnostic trouble code memory for ETC control module (N15/3) | AD27.19-P-6000A | |
| Fault code description for torque converter lockup clutch, ME-SFI | AD07.61-P-4000-34A | ||
| P0743 ■ | Read out diagnostic trouble code memory for ETC control module (N15/3) | AD27.19-P-6000A | |
| Fault code description for PWM-solenoid of torque converter lockup, ME-SFI | AD07.61-P-4000-35A |