Installing a new connecting rod bush - AR03.10-P-6111-03HA
Inspection data for connecting rod
| Number | Designation | Engines 604, 605.910/911/912, 606.910/912 | Engine 605.960/962, 606.961/962/964 | ||
|---|---|---|---|---|---|
| BE03.10-P-1006-01C | Dimension | Connecting rod bush inner ø(d) | mm | 26.012...26.018 | 28.018...28.024 |
| See picture in | AR03.10-P-6111AW | AR03.10-P-6111AW | |||
| BE03.10-P-1007-01C | Dimension | Connecting rod bush outside dia. | mm | 28.575...28.600 | 30.575...30.600 |
| BE03.10-P-1008-01C | Dimension | Connecting rod bush basic bore ø(d1) | mm | 28.500...28.521 | 30.500...30.525 |
| See picture in | AR03.10-P-6111AW | AR03.10-P-6111AW | |||
| BE03.10-P-1009-01C | Dimension | Piston pin play in connecting rod bush | mm | 0.007...0.018 | 0.007...0.018 |
| BE03.10-P-1010-01C | Dimension | Peak-to-valley height (Rz ) inside connecting rod bush | μM | 5 | 5 |
- Press out connecting rod bush, press out old connecting rod bush with new one.
Press in new connecting rod bush so that the oil drillings in the connecting rod bush are aligned with the oil drillings in the connecting rod (arrows).
- Turn diameter of connecting rod bush, ream.
- Dress side surfaces of connecting rod on a dressing plate.