Rivet oil pump chain - AR18.10-P-2140-02V

Fig 1: Identifying Case (602 589 00 98 00)

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

Fig 2: Identifying Riveting Tool (602 589 00 39 00)

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

Fig 3: Identifying Assembly Inserts (602 589 01 63 00)

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

Fig 4: Identifying Assembly Links (602 589 02 40 00)

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

Connect new oil pump chain (2) and old oil pump chain (1) with assembly clip-type fastener (3)
Slowly rotate crankshaft in direction of rotation of engine (arrow) until it is possible to connect the ends of the new oil pump chain (2).
Unhook old oil pump chain (1).

Fig 5: Identifying Oil Pump Chain And Clip-Type Fastener
Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
Connect the ends of the new oil pump chain (2) with the riveted link (4) Insert riveted link (4) from the front.

Fig 6: Identifying Oil Pump Chain And Riveted Link
Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
Place guide piece with the digit F2 into the press-on tool (arrow) and fix with bolt (28)

Fig 7: Locating Guide Piece With Press-On Tool
Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
Place moveable thrust piece with the digit 2 (arrow) into the press-on tool.

Fig 8: Locating Thrust Piece And Press-On Tool
Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
Place outer plate into the thrust piece with the digit 2 (arrow).

Fig 9: Locating Outer Plate And Thrust Piece
Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
Fit on press-on tool in such a way, that the rollers of the riveted link (4) are resting on the distance web (arrow).
Tighten spindle (6) up to solid resistance.
When turning the spindle (6) ensure, that the pins of the riveted link (4) are inserted in the holes of the outer plate (5).
Remove press-on tool.

Fig 10: Locating Rollers Of Riveted Link
Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
Turn thrust piece with the digit 2 onto rivet profile (arrow).

Fig 11: Locating Thrust Piece With Digit 2 Onto Rivet Profile
Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
Fit on press-on tool in such a way, that the pin is located exactly in the middle of the V-type support (arrow).
Tighten spindle (6).
The torque at the spindle (6) amounts to approx. 30-35 Nm (reference value).
Rivet pins of riveted link individually

Fig 12: Locating Spindle
Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
Check rivets (arrows) of pins, if necessary rivet pins again.

Fig 13: Locating Rivets Of Pins
Courtesy of MERCEDES-BENZ OF NORTH AMERICA.