Remove contacts from standard power timer coupling - AR00.19-P-0120-10A

Secondary release on version with lock tab (SPT) 

1. Using a suitable tool, at the line side unlock the lugs (1) on lock tab.
2. Open the tab.

Shown on a 4-pin SPT coupling 

Secondary release on version with spring (SPT) 

1. Insert a suitable tool between spring (1) and housing and then press spring (1) out.

Shown on a 7-pin JPT and SPT coupling 

Secondary release on version with slider (SPT) 

1. Using a suitable tool, push the slider out of the last detent in direction shown by arrow.

   Press carefully using the tool so that the gasket at the slider is not damaged.

Shown on a 6-pin SPT coupling 

Unpin female contacts from coupling (SPT) 

1. Insert blade holder with clamping pliers with JPT/SPT blade or MCP 2.8/ Fl.2.8/JPT/SPT blade from the front through the openings in contact cavity of coupling (1).

   This step compresses the spring shackles (2) on the female contact.

2. A slight tug on the corresponding cable will remove the female contact (1) from the coupling.