Function of calling up stored outside rearview mirror position - GF88.79-P-2005A

MODEL 210.081 /281, 210 (except 210.081 /281) as of 1.3.97 with CODE (275a) Memory package (driver's seat, steering column, rearview mirrors) 

MODEL 208 with CODE (275b) Memory package (driver's seat, rearview mirrors) 

Function prerequisites 

• Voltage not too high or too low and
• Circuit 15R ON or
• Circuit 15 ON or
• Affected vehicle door open

  and

• Simultaneously no other memory button actuated
• No button for manual seat, mirror, or where applicable, steering column adjustment actuated.

Function 

To call a stored rearview mirror position press one of the memory buttons 1 (S91/2s6), 2 (S91/2s7)  or 3 (S91/2s8)  . The front driver-side door control module (N69/1)  recognizes that a switch has been pressed and checks whether the prerequisites for this function are fulfilled, if so that front driver-side door control module (N69/1)  transmits the CAN message for setting the stored seat and mirror position to the front passenger-side door control module (N69/2)  and the driver-side ESA (with memory) control module (N32/1)  . Moreover, it performs the function of setting the stored outside mirror position  on the driver-side outside rearview mirror (M21/6). This is accomplished as long as the switch is pressed and as long as the prerequisites for the function are fulfilled.

The front passenger-side door control module (N69/2)  sets the stored outside rearview mirror position  on the passenger-side outside rearview mirror (M21/7).

When a stored outside rearview mirror position is called up the driver's seat is also moved to the stored seat position.