Connecting and disconnecting tester at rear axle level controller - AR32.30-P-0530-01A

Render the hydraulic system pressureless before commencing work on system. Wear protective clothing and eye protection.

Fig 1: Identifying Tester (126 589 14 21 00)

Rear axle level controller

Number	Designation			Model Series 140 with ride-height control/ ADS	Model Series 202 with ride-height control
BA32.30-P-1002-03A	Oil drain plug on level controller (reference value)	M10 x 1	NM	14	14

Rear axle level controller

Number	Designation			Model Series 203.2 with self-leveling suspension	Model Series 208 with self-leveling suspension
BA32.30-P-1002-03A	Oil drain plug on level controller (reference value)	M10 x 1	NM	14	14

Rear axle level controller

Number	Designation			Model 210 with level control / ADS
BA32.30-P-1002-03A	Oil drain plug on level controller (reference value)	M10 x 1	NM	14

Connect tester on Models 140, 210

Install test hose (038e) and bleed screws (038n) on distributor (038r) of the tester (038).

Fig 2: Identifying Test Hose, Bleed Screws And Distributor Of Tester
Unscrew drain plug from suspension-control module (3).
Use test hose (038e) to connect tester (038) to fitting (S2) on suspension-control module (3).

Layout on Model Series 140

Fig 3: Identifying Test Hose, Connect Tester, Fitting And Suspension-Control Module (Layout On Model Series 140)

Layout on Model Series 210

Fig 4: Identifying Test Hose, Connect Tester, Fitting And Suspension-Control Module (Layout On Model Series 210)

Connecting tester on Models 202, 203.2, 208

Install test hose (038g) and bleed screws (038n) on distributor (038r) of the tester (038).

Fig 5: Identifying Test Hose, Bleed Screws And Distributor Of Tester
Unscrew drain plug from suspension-control module (3).
Use test hose (038g) to connect tester (038) to fitting (A) on suspension-control module (3).

Fig 6: Identifying Test Hose, Connect Tester And Suspension-Control Module

Disconnect tester, Models 140, 202, 203.2, 208, 210

Attach discharge hose to the bleed screw (038n) on the tester (038).
Slowly open the bleed screw (038n) and allow the fluid to drain into a clean container.
The fluid can subsequently be refilled into the system for continued use.
Reclose the bleed screw (038n).
Disconnect tester (038) with test hose.
Screw the drain plug back into the suspension-control module (3), tightening to specified torque.