Removing and installing vacuum pump control module - AR43.05-P-1323K

MODEL 202, 208 with TRANSMISSION 722.616 

The control module is located in the right-hand side of the control module box 

Fig 1: Identifying Vacuum Pump Control Module Remove/Install Components

	Removing, installing
1	Remove cover from control module box	The control module is located in the right-hand side of the control module box
2	Detach vacuum line (d)	Installation: Ensure correct seating.
4	Release (arrows) and unplug connectors (a, b, c)
3	Remove brake booster vacuum pump control module (N65/3)
5	Install in the reverse order