Installing tilting/sliding roof panel - AR77.20-P-1000-02EB

Electrically operated glass tilting/sliding roof (code 414a)

TEST AND ADJUSTMENT VALUES FOR TILTING/SLIDING ROOF

Number	Designation			Model 202
BE77.20-P-1001-01A	Joint gap	Front of tilting/sliding roof panel	mm	0,15
BE77.20-P-1001-01A	Joint gap	Side and rear of tilting/sliding roof panel	mm	0,30

Special tools

Fig 1: Identifying Adjustment Gauge - 2 Each (140 589 04 21 00)

Fig 2: Identifying Installation Pliers (140 589 00 37 00)

Insert adjustment gauge (7) into holder (8) and arrest in direction of arrow.
NOTE: The adjustment gauge (7) ensures that the holder (8) and tilting/sliding roof (1) are positioned properly when installed.

Fig 3: Arresting Adjustment Gauge & Holder
Position tilting/sliding roof panel (2) and screw on nuts (3) loosely.

Fig 4: Identifying Tilting/Sliding Roof Panel Nuts

NOTE: It is necessary to grind or file a notch in the installation pliers (9) to prevent the tilting/sliding roof (2) from slipping out of the installation pliers (9) when it is tensioned.

Fig 5: Identifying Installation Pliers Dimension & Depth
Slightly tension tilting/sliding roof panel (2) with installation pliers (9) and tighten nut (3).
Remove adjustment gauge (7) and installation pliers (9).
Check tilting/sliding roof for proper function.
Check joint gaps around closed tilting/sliding roof panel (2) from outside.
Reinstall rubber bellows (6).
Reinstall molding (5).

Fig 6: Tensioning Tilting/Sliding Roof Panel Using Installation Pliers