Removing and installing positioning element in the headlamp unit - AR82.10-P-4301EA
MODEL 202 up to 31.8.96
| Removal | |||
| 1 | Open engine hood, move to upright position | AR88.40-P-1000E | |
| 2 | Fold open locking bar (1) | ||
| 3 | Take off housing cover (2) | ||
| 4 | Unclip red locking clip on positioning element (18) | ||
| 5 | Detach pneumatic line (19) | ||
| 6.1 | Turn left positioning element (18) 45° to the right and remove | ||
| 6.2 | Turn right positioning element (18) 45° to the left and remove | ||
| Installation | |||
| 7.1 | Insert left positioning element (18) and turn 45° to the left | ||
| 7.2 | Insert right positioning element (18) and turn 45° to the right | ||
| 8 | Fit on pneumatic line (19) | ||
| 9 | Clip reflector into place at positioning element (18) and secure with red locking clip | ||
| 10 | Fit on housing cover (2) | ||
| 11 | Close locking bar (1) | ||
| 12 | Check headlamp adjustment, correct | AP82.10-P-8260A |