Firing installed emergency tensioning retractor; Instructions on disposal of airbags, side airbags and emergency tensioning retractors; Operation of firing device; Adapter cable for firing of airbags and emergency tensioning retractors - AR91.40-P-0611-03A
| AR91.40-P-0611-03A | Firing installed emergency tensioning retractor | ||
| Instructions on disposal of airbags, side airbags and emergency tensioning retractors | all | OS91.00-P-0001-01A | |
| Operation of firing device | AR91.60-P-0611-04A | ||
| Adapter cable for firing of airbags and emergency tensioning retractors | WF58.50-P-9160-01A |
Adapter cable connection schematic
Application of firing device
To ignite the emergency tensioning retractors with the ETR test connector (X11/7) or on vehicles with airbag with the SRS test connector (X11/13), a separate self-made adapter cable is required which is not included with the firing device, part no.
- Switch off ignition, disconnect negative pole on battery and cover.
- To fire emergency tensioning retractors, disconnect 4-pin connector (X11/7) below front right door sill molding.
- Press pressure switch (2) and simultaneously pressure switch (3) at the specified safety distance (10 m, corresponds to ignition cable length). After triggering, control lamp (5) comes on.
- Connect connector on adapter cable (10) with 4-pin plug and repeat step 5.