Removing and installing lock cylinder on glove compartment lid - AR68.10-P-1250E
MODEL 202
Fig 1: Identifying Lock Cylinder On Glove Compartment Lid Remove/Install Components - Model 202 (1 Of 2)
Fig 2: Identifying Lock Cylinder On Glove Compartment Lid Remove/Install Components - Model 202 (2 Of 2)
| Removal | |||
|---|---|---|---|
| 1 | Open glove compartment lid (2) and unscrew screws (1) | ||
| 2 | Remove housing (4) on glove compartment lid (2) | ||
| 3 | Cut notch in driver lug (3) with knife at point marked (arrow), break open with combination pliers and completely remove | ||
| 4 | Insert ignition key into lock cylinder (5) and remove lock cylinder (5) from lock housing (4) with key | ||
| Installation | |||
| 5 | Insert lock cylinder (5) into housing (4) with ignition key so that lug (arrow) on left makes contact with housing stop | ||
| 6 | Remove ignition key and secure lock cylinder (5) from falling out with adhesive tape | ||
| 7 | Position housing (4) with handle side (6) on suitable surface | ||
| 8 | Install new driver lug (3) with installation tool (7) on lock cylinder (5) and housing (4) so that it catches audibly Installation tool for driver lug |
||
| Lock cylinder | WF58.50-P-6810-01A | ||
| 9 | Remove adhesive tape and position housing (4) on glove compartment lid (2) and screw in screws (1) | ||
| 10 | Carry out function check |