Removing and installing headliner - AR68.30-P-4300FA

MODEL 210.2 

Fig 1: Identifying Headliner Components - Model 210.2

	Removal, installation
1.1	Open sliding/pop-up roof panel	Electric sliding/pop-up roof (code 414a)
2	Remove inside mirror (2)	Pull inside rearview mirror vertically downward with force on one side and remove (arrow). Installation:  Position inside rearview mirror on one side and press upward until it catches securely.
3	Remove overhead control panel control module		AR82.20-P-1000K
4	Remove sun visors
5	Unscrew screw from mounting bracket for left and right sun visors
6	Remove rear dome lamp		AR82.20-P-0113F
7	Remove grab handles on side (4 each)
8	Remove load anchors (4 each)
9	Pull edge guard off of front and rear door cutout in area of headliner (1)
10	Remove paneling from A-pillar on left and right		AR68.30-P-4050F
11	Remove paneling from B-pillar on left and right	Do not remove seat belt end fitting	AR68.30-P-4700F
12	Remove paneling from C-pillar on left and right	Do not remove seat belt end fitting	AR68.30-P-4490FA
13	Remove rear roof frame paneling		AR68.30-P-4470F
14	Lay down backrests of front seats
15	Remove head restraints of rear seats
16.1	Remove rail (3) Electric sliding/pop-up roof (code 414a)
17.1	Unhook headliner (1) from sliding/pop-up roof frame at rear (arrows)	Electric sliding/pop-up roof (code 414a)
18	Slide headliner (1) toward front	Unhook both mounts (4) from sliding roof frame. Installation:  Ensure that mounts (4) reach into the sliding roof frame simultaneously when sliding back the headliner.
19	Remove headliner (1) and take out through rear door.
20	Install in opposite order