Removing and installing radio - AR82.60-P-7502A: Notes

Model 129 

with single-block unit, two-component control module and CD drive with radio control module, 1st generation 

Fig 1: Identifying Radio Components (1 Of 2)

Fig 2: Identifying Radio Components (2 Of 2)

	Removal, installation
1	Disconnect ground cable of battery		AR54.10-P-0003A
2	To check, press radio into console at outer left and right cover (1) toward front of vehicle	The retaining clips which clip into the radio at the bottom right and left (arrow) can only be unclipped when the radio is completely inserted.
3	Pull out radio (A1), radio control module (A2/4) or CD drive and radio control module (A2/2)	For this purpose slide removal plates (2) in up to stop at a distance of approx. 5 mm from outer edge of cover (1) at an angle of approx. 45° between cover (1) and wooden cover, lift slightly and pull out.
			Fig 3
4	Disconnect electrical connectors
5.1	Convert line-out unit (sound system) (A2/1)	Only with code 810 and when replacing Becker Mexico Diversity radios up to approx. 08/90 and Becker Mexico Compact-Disc up to approx. 01/92.
6	Install in the reverse order
7	Encode radio		AR82.60-P-7502-01C

Fig 3: Identifying Removal Tool (129 589 00 05 00)