Removing and installing door liner on front door - AR72.10-P-1000A

MODEL 129.### ## as of 125158 

Fig 1: Identifying Door Liner On Front Door Components

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

	Removing, installing
1	Open crank window
2	Unclip mirror triangle cover (2) from above using assembly wedge, pull upwards and remove		Fig 2
3	Unclip entrance lamp, disconnect electrical connection and remove entrance lamp
4	Unclip SRS cover (3) and unscrew screw (4)	With code 292 (front side airbag)
5	Open door pocket cover
6	Unclip and remove cover (5) in door pocket
7	Unscrew screws (6) in the area of the front and rear door pocket
8	Detach chrome surround (7)
9	Remove lock escutcheon (8)
10	Press door lining (1) off door inner panel at bottom, front and rear using assembly wedge	Guide each assembly wedge straight to the clips.	Fig 2
11	Lift door lining (1) out of retaining clips at the top of the sealing rail using assembly wedge and at the same time pull away from the inner door panel	Installation  : Press on door lining in area of interior door control so that the lug (arrow) engages in the inner door panel (arrow). Guide entrance lamp electrical connection through the recess in the door lining	Fig 2
12	Unhook control cable (9) on interior door control
13	Disconnect seat adjuster electrical connectors (10) on door lining
14	Remove door lining (1) and put down on clean base
15	Check films and clips on inner door panel and replace if necessary.	Stick door film onto inner door panel.	*BR00.45-Z-1004-02A
16	Check clips on door lining (1) and replace if necessary.
17	Install in reverse order

Fig 2: Identifying Assembly Wedge (110 589 03 59 00)

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

REPAIR MATERIALS

Number	Designation	Order number
BR00.45-Z-1004-02A	Adhesives	A 001 989 30 71