Removing and installing rear axle sensor for headlamp range adjustment with Xenon headlamps - ra82001404084x(4084)
Model 140
| Electrical connection (1) | disconnect, reconnect. |
| Connecting rod (2) | detach and unhook, hook in and fasten. |
| Screws (3) | unscrew, screw in. |
| Rear axle sensor (A51) | remove, install.
NOTE:
Adjust xenon headlamps to zero position with HHT, see Diagnosis Manual, Body. Then check headlamp adjustment with adjustment unit and adjust as necessary, see Maintenance Manual, Volume 3.
|