Removal and installation of windshield washer system reservoir - ra82001400700x(0700)
Model 140
Preliminary work:
Front bumper removed (88-200).
Right lamp unit removed (82-052).
REMOVAL
| Filler pipe (4) with bolt | unscrew and take out. |
| Lines to heat exchanger with screws (1) | slacken and pull off. |
| 4 bolts on engine compartment lining below | |
| washer reservoir | unscrew. |
| Washer fluid indicator (2) | withdraw. |
| Washer reservoir with nuts (3) | unscrew. |
| Washer reservoir | take out downwards. |
| Washer pump | withdraw. |
Installation
Installation is performed in reverse order.
NOTE:
Coat filler pipe (4) at reservoir with lubricant (e.g. soft soap) to ensure the rubber seal does not drop into the reservoir when the filler connection is pressed into the reservoir.