Removal and installation of the rear door lock - ra72001400251x(0251)
WARNING: This page does not describe the selected car, but rather 42 other vehicles, including the 1999 Mercedes-Benz S600, 1999 Mercedes-Benz S500, 1999 Mercedes-Benz S420, 1999 Mercedes-Benz S320, and 1999 Mercedes-Benz CL600. However, it is still accessible from the selected car via links, so may be relevant.
Model 140
Preliminary work:
Door liner removed (Removal and installation of the lining on the rear door )
Exterior door handle on rear door removed (Removal and installation of the exterior handle on the rear door )
| Vapor seal on interior door panel | detach and remove. |
| Crank window | close. |
| Screw (2 pieces) for lock cover (1) | screw out (WAF8). |
| Lock cover (1) | remove. |
| Linkage for interior door actuation (2) and central locking linkage (3) on door lock (4) | remove or unhook. |
| Screws (arrows) on door lock (4) | screw out. Nm: 8. When installing first tighten the front screw. |
| Door lock (4) | remove through installation opening in door inner panel. |
| Reinstall | in opposite order. |
Removal, installation
- Pull off vapor seal on interior door panel and close crank window.
- Screw out screws (arrows) and remove lock cover (1) through the installation opening.
- Remove or unhook linkage for interior door actuation (2) and central locking linkage (3) on door lock (4).
- Screw out screws (arrows) on door lock (4). 8 Nm.NOTE: When installing, first tighten the front screws.
- Screw out door lock (4) through the installation opening in the door inner panel.
- Reinstall in opposite order.