Pull bearing inner race off rear axle shaft flange - AR35.20-P-0130-02A

WARNING: This page does not describe the selected car, but rather 42 other vehicles, including the 1999 Mercedes-Benz S600, 1999 Mercedes-Benz S500, 1999 Mercedes-Benz S420, 1999 Mercedes-Benz S320, and 1999 Mercedes-Benz CL600. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Thrust Piece (124 589 02 34 00)

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

Fig 2: Identifying Puller (001 589 50 33 00)

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

Fig 3: Identifying Clamping Pliers (140 589 01 34 00)

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

Fig 4: Identifying Clamping Pliers (201 589 00 34 00)

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

Special tool assignment:

Models 129, 140, 163, 170, 202, 203, 208, 209, 210, 215, 220:

Thrust piece 124 589 02 34 00,

Puller 001 589 50 33 00

Model 140, 163, 215, 220:

Clamping pliers 140 589 01 34 00

Model 129, 170, 202, 203, 208, 209, 210:

Clamping pliers 201 589 00 34 00

Screw clamping pliers onto puller and tighten.
Clamp rear axle shaft flange in vise with aluminum jaws.
Fit thrust piece (010e)with large diameter on rear axle shaft flange.

Fig 5: Identifying Thrust Piece On Rear Axle Shaft Flange
Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
Slip fully assembled puller over bearing inner race.
At the upper grooves, clamp the clamping pliers over the conical sleeve of the puller.
Pull inner bearing race off rear axle shaft flange using puller and remove.

Fig 6: Identifying Inner Bearing Race And Flange Puller

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.