LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 1995 >> E420 >> Repair and Diagnosis >> External Pages >> Different car >> Section 3 (Suspension - Rear) >> Removal & Installation >> Radius Rod >> Removal

Radius Rod: Removal

WARNING: This page is about a different car, the 1994 Mercedes-Benz C280 and 1994 Mercedes-Benz C220. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support vehicle. Loosen radius rod-to-axle carrier nut. Push wheel carrier forward to unload radius rod. Remove radius rod-to-axle carrier bolt and nut. See Figure.
  2. Remove radius rod-to-wheel carrier bolt and nut. Using a puller, remove radius rod from wheel carrier. Replace radius rod assembly if rubber mounts are worn or damaged.
scientia non olet · About LEMON Manuals