LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 1995 >> E420 >> Repair and Diagnosis >> External Pages >> Different car >> Section 25 (Automatic Transmission - 140 Chassis) >> Testing & Repair >> Removing and installing wire cable for parking lock interlock - AR27.60-P-1000 >> Removing and installing wire cable for parking lock interlock - AR27.60-P-1000A

Removing and installing wire cable for parking lock interlock - AR27.60-P-1000A

WARNING: This page does not describe the selected car, but rather 42 other vehicles, including the 1999 Mercedes-Benz S600, 1999 Mercedes-Benz S500, 1999 Mercedes-Benz S420, 1999 Mercedes-Benz S320, and 1999 Mercedes-Benz CL600. However, it is still accessible from the selected car via links, so may be relevant.

TRANSMISSION 722.620 # up to 0001680, 722.621 # up to 0001976, 722.622 

Fig 1: Identifying Wire Cable For Parking Lock Interlock Components
G04679510Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
REMOVING
INSTALLING
Removing and installing wire cable/steering lock    
1 Remove cover below left of instrument panel   ra68001400150x
2 Unhook wire cable/steering lock (79) by pressing in the locking tongues and at the same time pressing (arrows) against the steering lock (figure A)  IMPORTANTInstallation  : Position key in steering lock in position "1"  
3 Remove stop lamp switch   AR42.10-P-0040A
4 Unhook wire cable/steering lock (79) at the release lever (77) (arrow) (figure B)     
5 Compress locking device (arrows) and at the same time push the wire cable/steering lock upwards out of the mount on the pedal bearing bracket (figure C)     
6 Remove wire cable/steering lock    
7 Install in reverse order    
8 Adjust wire cables for parking lock interlock   AR27.60-P-0965A 
  Removing wire cable/transmission     
9 Remove cover below left of instrument panel   ra68001400150x
10 Pull off entrance strip upwards    
11 Remove A-pillar footwell cover    
12 Unscrew accelerator pedal from floor panel    
13 Remove driver side floor lining complete NOTES Do not fold up floor carpet, foamed insulating material cracks.  
14 Remove air duct for rear compartment heating    
15 Unhook wire cable/transmission (80) at release lever (77) (arrow) (figure B)     
16 Compress locking device (arrows) and at the same time push the wire cable/transmission upwards out of the mount on the pedal bearing bracket (figure C)     
17 Disconnect wire cable/transmission (80) on transmission (figure D)  NOTES To install and remove, position selector lever or range selector lever in position "P" and leave in position "P" when wire cable/transmission is removed AR27.60-P-0500-05A 
18 Remove rubber boot on tunnel    
19 Open cable straps behind cover on left of tunnel and remove wire cable/transmission IMPORTANTInstallation  : Attach wire cable/transmission in the bracket on the jacket tube  
20 Install in reverse order    
21 Adjust wire cables for parking lock interlock   AR27.60-P-0965A