Remove/install oil pump - AR27.10-P-0400A
WARNING: This page does not describe the selected car, but rather 42 other vehicles, including the 1999 Mercedes-Benz S600, 1999 Mercedes-Benz S500, 1999 Mercedes-Benz S420, 1999 Mercedes-Benz S320, and 1999 Mercedes-Benz CL600. However, it is still accessible from the selected car via links, so may be relevant.
TRANSMISSION 722.6
| Remove/Install | |||
|---|---|---|---|
| 1 | Remove transmission with torque converter | Model 129, 140, 170, 202, 208, 210 | AR27.10-P-0500B |
| Model 163 | AR27.10-P-0500GH | ||
| Model 203 without 4MATIC, 209 | AR27.10-P-0500P | ||
| Model 203 with 4MATIC | AR27.10-P-0500PW | ||
| Model 211 with 4MATIC | AR27.10-P-0500TW | ||
| Model 215, 220 without 4MATIC | AR27.10-P-0500I | ||
| Model 220 with 4MATIC | AR27.10-P-0500IW | ||
| 2 | Put transmission down on workbench | ||
| 3 | Take transmission housing (1) off torque converter housing (2) | ||
| *BA27.40-P-1002-01A | |||
| 4 | Pull torque converter housing (2) off transmission housing (1) | ||
| 5 | Unscrew internal Torx drive bolts (4a) of oil pump (4) | *BA27.40-P-1003-01A | |
| 6 | Screw two opposed bolts (a) into the oil pump housing (4) and press the oil pump (4) out of the converter housing (2) by applying light blows with a plastic hammer. | ||
| Inspect | |||
| 7 | Check oil pump (4) | Dismantle and assemble oil pump |
AR27.50-P-0720-01A |
| 8 | Check Teflon rings (5a) of multi-disk brake B1 (5), replace if necessary | ||
| 9 | Install in the reverse order |
| Number | Designation | Transmission 722.6 except 722.660/661/662 /663/666/674 | Transmission 722.660/661/66 2/663/666/674 | |
|---|---|---|---|---|
| BA27.40-P-1002-01A | Bolt, transmission housing to torque converter housing | Nm | 20 | 20 |
| BA27.40-P-1003-01A | Bolt, oil pump with multi-disk brake B1 to torque converter housing | Nm | 20 | 20 |