LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 1995 >> E420 >> Repair and Diagnosis >> External Pages >> Different car >> Section 25 (Automatic Transmission - 140 Chassis) >> Testing & Repair >> Dismantling and assembling output shaft with center and rear gear set - AR27.50-P-0810A >> Checking and adjusting end play between shim and circlip - AR27.50-P-0810-01A

Checking and adjusting end play between shim and circlip - AR27.50-P-0810-01A

WARNING: This page does not describe the selected car, but rather 42 other vehicles, including the 1999 Mercedes-Benz S600, 1999 Mercedes-Benz S500, 1999 Mercedes-Benz S420, 1999 Mercedes-Benz S320, and 1999 Mercedes-Benz CL600. However, it is still accessible from the selected car via links, so may be relevant.
Test values for gear set

Number Designation Transmission 722.6 Transmission 722.9
BE27.50-P-1005-01A Axial play between shim and circlip mm 0.15...0.6 0.15...0.60
  1. Using a feeler gage, check axial play "S" between shim (42e) and circlip (42f).

    IMPORTANT Push multi-disk clutch K3 (44) hard by hand in direction of arrow.

  2. Remove shim (42e) and measure thickness.
  3. Adjust play with shim (42e).

    IMPORTANT Shims (42e) are available in thicknesses 3.1 to 3.7 mm. They are available in graduations of 0.3 mm.

    Fig 1: Identifying Multi-Disk Clutch K3
    G04606593Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
scientia non olet · About LEMON Manuals