Removing, installing and adjusting starter lockout switch - RA27037220130X(27-130)
WARNING: This page does not describe the selected car, but rather 42 other vehicles, including the 1999 Mercedes-Benz S600, 1999 Mercedes-Benz S500, 1999 Mercedes-Benz S420, 1999 Mercedes-Benz S320, and 1999 Mercedes-Benz CL600. However, it is still accessible from the selected car via links, so may be relevant.
Operation number of the operation texts and work units or standard texts and flat rates:
27-1280
| Plug of starter lockout switch (8) | Turn locking device upwards and press of carefully using two screwdrivers (items 1 and 2). |
| Shift rod (9) | Take off after removing locking clip (item 3). |
| Range selector lever (52) | Remove after unscrewing hexagon bolt (51). When installing, ensure that driver (54) engages in range selector lever (item 4). |
| Starter lockout switch (53) | To remove, unscrew hexagon bolts (55). When installing, insert drift (4 mm dia.) through driver (54) and locating bore in shift housing and locate starter lockout switch (item 5). |
Removing and installing
- Release locking device for starter lockout switch plug (8) by turning white plastic ring (arrow) upwards in direction of arrow.
- Carefully press off plug using two screwdrivers at the cable output and the tab.
- Unhook shift rod (9) after removing the retaining clip.
- Unscrew hexagon bolt (51) and pull off range selector lever (52).
Installation note
Attach range selector lever in such a way that the driver (54) engages in the lever.
- Unscrew both bolts (55) and remove starter lockout switch (53).
Installation note
Move range selector lever to position "N".
Insert splint or drill bit (4 mm dia.) through driver (54) into locating bore in shift housing, then tighten retaining bolts (55). Pull out locating pin (arrow).
- Install in the reverse sequence.