Removing and installing tensioning rail - RA05001203300X(05-3300)
WARNING: This page does not describe the selected car, but rather 42 other vehicles, including the 1999 Mercedes-Benz S600, 1999 Mercedes-Benz S500, 1999 Mercedes-Benz S420, 1999 Mercedes-Benz S320, and 1999 Mercedes-Benz CL600. However, it is still accessible from the selected car via links, so may be relevant.
Preceding work:
Timing case cover removed (01-2100) .
| Crankshaft sprocket (1) | mark with coloured dot relative to timing chain (4). |
| Tensioning rail (2) at bearing pin (17) | pull off. |
| Tensioning rail (2) | install, pay attention to coloured marking. |
NOTE:
The plastic lining (18) (sliding surface) is clipped into the tensioning rail (2) and can be replaced individually.
The bearing pin (17) is knocked into the crankcase.
Projection 40 mm.