Armature and solenoid at camshaft adjuster - RA05001192175X(05-2175)
WARNING: This page does not describe the selected car, but rather 42 other vehicles, including the 1999 Mercedes-Benz S600, 1999 Mercedes-Benz S500, 1999 Mercedes-Benz S420, 1999 Mercedes-Benz S320, and 1999 Mercedes-Benz CL600. However, it is still accessible from the selected car via links, so may be relevant.
| Solenoid (Y49) | unbolt, bolt on. |
| Solenoid (Y49) | coat sealing surface with sealant 002 989 47 20 10. |
| M6 X 16 bolts (1) | tighten. |
| Front cover (7) | remove, install (05-2170) . |
| Armature (4) with M5 X 11 bolt (3) | unscrew, screw on; counter-hold armature (4) at flats (arrow) for this step; see table for tightening torque; armature (4) can be fitted onto control plunger (18) only in fixed position (arrow).
NOTE:
The armature (4) together with the control plunger (18) must move freely from stop to stop after the nut (6) has been tightened to the specified torque of 65 Nm. For operational reasons, the different versions of the armature (4) and of the solenoid (2) must only be installed in the specified combination (see table for matching). |
MATCHING ARMATURE AND SOLENOID
| 1st version | Part no. | Size A in mm | Size B in mm | Identification | |
| Armature (4) | 104 051 04 43 | - | 21 | see arrow X | |
| Solenoid (2) | 104 050 01 77 | 27.1 | - | - | |
| 2nd version | |||||
| Armature (4) | 119 051 00 43 | - | 23 | see arrow Y | |
| Solenoid (2) | 119 051 00 77 | 29.1 | - | - |
TIGHTENING TORQUES IN NM AND TIGHTENING ANGLE
| Bolt of armature to control plunger | 1st version(1) bolt+washer | 7 | ||||
| 2nd version(2) collar bolt | 5+ | |||||
| Tightening angle | 90° | |||||
| Bolts of solenoid to front cover | 10 | |||||
|
||||||