Removing and installing front engine mounts - RA220A1042110X(22-2110)

WARNING: This page does not describe the selected car, but rather 42 other vehicles, including the 1999 Mercedes-Benz S600, 1999 Mercedes-Benz S500, 1999 Mercedes-Benz S420, 1999 Mercedes-Benz S320, and 1999 Mercedes-Benz CL600. However, it is still accessible from the selected car via links, so may be relevant.

Operation no. of operation texts and work units or standard texts and flat rates:

22-1260-1700

Models 124, 129, 140

Fig 1: Identifying Front Engine Mounts Remove/Install Components

Ground cable at battery	disconnect, connect.
Intake air scoop	remove, install (09-0060) .
Models 124, 129:	take off fan shroud ring and fan shroud, fit on (20-3400) .
Bottom engine compartment panel	remove, install.
Bolts (1)	unscrew, screw on, tightening torque 25 Nm.
Engine	raise, lower.
Bolts (7)	unscrew, screw on, tightening torque 55 Nm.
Engine mounts (2) and shield (3)	remove, install, pay attention to installation note.

Special tools

Fig 2: Identifying Special Tool (001 589 66 21 00)

Fig 3: Identifying Special Tool (001 589 72 21 00)

Installation note

Engine mounts (2) and shields (3) on the left and right are identical.

The anti-twist lock (pin) in the engine mount (2) must be inserted into the hole in the shield (3) and into the retaining slot in the engine carriers (4 or 5).

Model 140

Remove left engine mount together with engine carrier. Unscrew securing bolts (1). Push high pressure hose of tandem pump up and out.

Fig 4: Identifying Engine Mount With Bolts