Pulling off rubber mount with grooved ball bearing and front protective cap - AR41.10-P-0100-01DA

WARNING: This page does not describe the selected car, but rather 42 other vehicles, including the 1999 Mercedes-Benz S600, 1999 Mercedes-Benz S500, 1999 Mercedes-Benz S420, 1999 Mercedes-Benz S320, and 1999 Mercedes-Benz CL600. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Two-Legged Puller (000 589 88 33 00)

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

Fig 2: Identifying Puller Arms (129 589 00 34 00)

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

Insert puller legs between rear protective cap (if installed) and propeller shaft intermediate bearing (see detail).

Pull rubber mount (7) together with grooved ball bearing and front protective cap (if installed) off the joint fork.
Protective caps are not installed at the grooved ball bearing, on either the stem or fork side on models 203, 208, 210, 170 and with models 129, 140, 202 as of 6/95.

Fig 3: Pulling Off Rubber Mount With Grooved Ball Bearing And Front Protective Cap
Courtesy of MERCEDES-BENZ OF NORTH AMERICA.