Removal and installation of electronic accelerator actuator with the throttle valve assembly - ra30lh1041262x(1262)
WARNING: This page does not describe the selected car, but rather 42 other vehicles, including the 1999 Mercedes-Benz S600, 1999 Mercedes-Benz S500, 1999 Mercedes-Benz S420, 1999 Mercedes-Benz S320, and 1999 Mercedes-Benz CL600. However, it is still accessible from the selected car via links, so may be relevant.
Engine 104 LH-injection
Preceding work
Removing and installing hot wire air mass sensor (07.4-1453)
Operation No. of operation texts and operation values or standard texts and flat rates ------------------.30-1262
| Throttle valve control linkage | at electronic accelerator actuator with throttle valve assy (M16/1), detach, attach. |
| Return spring (arrow) | detach, attach. |
| Electronic accelerator actuator connector | detach, fit on. |
| Screws (38) | unscrew, screw in. Tightening torque 25 Nm as reference value. |
| Electronic accelerator actuator with throttle valve assembly (M16/1) | take off, fit on. Installation instruction Clean sealing surface, renew gasket (36). Check accelerator control, set if necessary (30-1010 ). |
| Electronic accelerator control unit fault memory | read, erase if necessary (see Diagnosis Manual Engine, Volume 2, Index 0). |