LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 1995 >> C220 >> Repair and Diagnosis >> External Pages >> Different car >> Section 85 (Body Noises, Noise Insulation - 140 Chassis) >> General Maintenance >> Removing and reinstalling bottom noise encapsulation panels - wh9490pkw0000x(9490)

Removing and reinstalling bottom noise encapsulation panels - wh9490pkw0000x(9490)

WARNING: This page does not describe the selected car, but rather 42 other vehicles, including the 1999 Mercedes-Benz S600, 1999 Mercedes-Benz S500, 1999 Mercedes-Benz S420, 1999 Mercedes-Benz S320, and 1999 Mercedes-Benz CL600. However, it is still accessible from the selected car via links, so may be relevant.

Models 124.1/3 to 6/93, 126.1 (USA) from 1986, 140.34 to 6/93, 201.1 

Fig 1: Locating Front Bottom Noise Encapsulation Panel Screws
G05441494Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

Front bottom noise encapsulation panel, screw-mounted

Fig 2: Locating Front Bottom Noise Encapsulation Panel Clamp
G05441495Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

Front bottom noise encapsulation panel with quick-release clamps

Fig 3: Locating Center Bottom Noise Encapsulation Panel Screws (Model 140)
G05441496Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

Model 140, center bottom noise encapsulation panel

Fig 4: Locating Rear Bottom Noise Encapsulation Panel Screws
G05441497Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

Rear bottom noise encapsulation panel

Bottom noise encapsulation panels remove, install, for this purpose screw out sheet metal screws (arrows), screw in or open quick-release catches (handles perpendicular to driving direction), close (handles in driving direction).
NOTE: If lost the quick-release catches used on some vehicles can be replaced with the standard combination screws.
 
For this purpose replace clips with sheet metal nuts. Observe item 1 when reinstalling.
Corrosion protection repair if damaged.
  1. Installing bottom noise encapsulation panel 

Install bottom noise encapsulation panel so that the cutouts engage in the lugs on the side sections (3).

Fig 5: Locating Bottom Noise Encapsulation Panel
G05441498Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

Press bottom noise encapsulation panel (1) upward until the edges of the side sections (3) snap over the bottom panel (1).

Fig 6: Pressing Bottom Noise Encapsulation Panel Upward
G05441499Courtesy of MERCEDES-BENZ OF NORTH AMERICA.