Removal and installation of the closing aid supply pump - ra72001400262x(0262)
WARNING: This page does not describe the selected car, but rather 42 other vehicles, including the 1999 Mercedes-Benz S600, 1999 Mercedes-Benz S500, 1999 Mercedes-Benz S420, 1999 Mercedes-Benz S320, and 1999 Mercedes-Benz CL600. However, it is still accessible from the selected car via links, so may be relevant.
Model 140
| Lamp holder on rear lamp, left | open, tip to side and remove. |
| Side panelling (1) in trunk, left | remove (2 clips). |
| Supply pump for closing aid (M14/3) | pull out toward rear. |
| Supply pump | remove from plastic carrier (2) and noise encapsulation (3) |
| Plug connector | disconnect on supply pump (use connecting and pulling aid). |
| Pneumatic lines | pry off on supply pump with open-end wrench (WAF 7 mm) and pull off. |
| Supply pump | remove. |
| Reinstall in opposite order. | |
| Perform function check. |
Diagnosis description: see Diagnosis Manual, Body, Volume I
Electric Wiring Diagrams:
see "Electric Wiring Diagrams" Model 140, Volume 2.