Removal and installation of front seat belt automatic height adjuster - ra91001400505x(0505)
WARNING: This page does not describe the selected car, but rather 42 other vehicles, including the 1999 Mercedes-Benz S600, 1999 Mercedes-Benz S500, 1999 Mercedes-Benz S420, 1999 Mercedes-Benz S320, and 1999 Mercedes-Benz CL600. However, it is still accessible from the selected car via links, so may be relevant.
Model 140
REMOVAL
| Seat | move forward and up at rear. |
| Cap (4) | pull off toward rear. |
| Clip (5) | turn approx. 90° and remove. |
| End of control cable | remove from fixed mount (3) by pressing catch together. |
| Seat | move toward rear and up at front. |
| Footmat | lift together with damping element. |
| Screw (1) on control cable mount (2) | screw out. |
| Seat | loosen at front and lift, expose control cable and remove. |
| Seat | move forward. |
| Entry strips on entry | remove. |
| Edge protector on B-pillar | press off. |
| 2 screws (6) on B-pillar covering at bottom (7) | screw out and remove covering upward. |
| Clips on B-pillar covering (8) | press in with screwdriver (arrows) and remove covering downward. |
| Control cable guide (9) | remove with screwdriver (arrows). |
| Control cable | press out of clips (13 and 14). |
| Remaining travel spring with attachment fitting (15) | unhook downward. |
| Upper belt guide fitting (10) | screw off. |
| Screw (11) on belt height adjuster (12) | screw out. |
Do not move belt height adjuster (12) by hand. |
Installation note
The mounting points for the control cable (2, 13, 14) are provided with a white mark.
Perform function check: Move seat forward and back, the belt height adjuster should move accordingly.