LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 1995 >> C220 >> Repair and Diagnosis >> External Pages >> Different car >> Section 73 (Rear Axle - 140 Chassis) >> Testing & Repair >> Replace radial sealing ring on connecting flange of rear axle shaft - AR35.31-P-0540A >> Pulling off and pressing on grooved ball bearing connecting flange - AR35.31-P-0540-04A

Pulling off and pressing on grooved ball bearing connecting flange - AR35.31-P-0540-04A

WARNING: This page does not describe the selected car, but rather 42 other vehicles, including the 1999 Mercedes-Benz S600, 1999 Mercedes-Benz S500, 1999 Mercedes-Benz S420, 1999 Mercedes-Benz S320, and 1999 Mercedes-Benz CL600. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Puller (001 589 50 33 00)
G04685199Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
Fig 2: Identifying Spring Collet (140 589 00 34 00)
G04685200Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
  1. Disconnect grooved ball bearing from connecting flange.
    Fig 3: Identifying Connecting Flange
    G04685201Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

    Pressing on grooved ball bearing 

    IMPORTANT

    On vehicles with ASD, the chamfer or groove (arrow) must point towards the shaft. An installed position is not specified on vehicles with ASR.

  2. Press on deep-groove ball bearing (33c) using suitable tube (033c) until it abuts the flange.

    Location of connecting flange on ASD version 

    Fig 4: Locating Connecting Flange On ASD Version
    G04685202Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
scientia non olet · About LEMON Manuals