Driving out and driving in ASD differential pin and roll pin - AR35.41-P-0560-02C

WARNING: This page does not describe the selected car, but rather 42 other vehicles, including the 1999 Mercedes-Benz S600, 1999 Mercedes-Benz S500, 1999 Mercedes-Benz S420, 1999 Mercedes-Benz S320, and 1999 Mercedes-Benz CL600. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Drift Punch (123 589 06 15 00)

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

Fig 2: Identifying Drift Punch (126 589 02 15 00)

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

Removal

Using a suitable drift, drive roll pin (19) for the differential pin (16) out of the differential housing (13).
Using drift punch 123 589 06 15 00 for 185 mm dia. crown wheel or 126 589 02 15 00 for 210 mm dia. crown wheel, drive differential pin (16) out of differential housing.
Installation
Using drift punch 123 589 06 15 00 for 185 mm dia. crown wheel or 126 589 02 15 00 for 210 mm dia. crown wheel, drive differential pin (16) into differential housing, paying attention to the bore for the roll pin (19).
Drive in roll pin (19) until it seats centrally in the differential pin.
Replace roll pin (19).

Fig 3: Identifying Differential Housing, Bevel Gear, Pin, Side Gear, Roll Pin And Friction Washer
Courtesy of MERCEDES-BENZ OF NORTH AMERICA.