Remove and install the reveal molding at the side of the windshield - ra68001400405x(0405)
WARNING: This page does not describe the selected car, but rather 42 other vehicles, including the 1999 Mercedes-Benz S600, 1999 Mercedes-Benz S500, 1999 Mercedes-Benz S420, 1999 Mercedes-Benz S320, and 1999 Mercedes-Benz CL600. However, it is still accessible from the selected car via links, so may be relevant.
Model 140 - A. Sedan, B. Coupe
- Sedans
Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
Edge protector remove in area of molding on A-pillar. Molding (Fig 1) slide up and press off of clamps with plastic wedge. Molding (Fig 2) slide down toward inside and pull out of panelling at top. Reinstall in opposite order. - Coupes
| Cover (arrows) on handle (1) | press off and screw off handle. |
| Panelling on rear pillar (2) in front area | unclip at reveal molding (3) and roof frame. |
| Reveal molding (3) | pull out of retaining clips (5 each) on A-pillar (arrows) and remove upward, simultaneously pivot out below rear pillar panelling (2). |
| When reinstalling | insert clips (5 each) on A-pillar. |
| Reveal molding (3) | align on A-pillar and press into clips (5 each). |
| Plastic clips (arrow) on rear pillar panelling (2) | connect with reveal molding (3) and clip rear pillar panelling (2) onto roof frame. |
| Handle (1) | screw on and press on covers (arrows). |
| Plush lip on sealing frame (4) | pry over reveal molding (3) and rear pillar panelling (2). |