Remove grooved ball bearing in rear of transmission housing - AR27.50-P-0601-01A

WARNING: This page does not describe the selected car, but rather 42 other vehicles, including the 1999 Mercedes-Benz S600, 1999 Mercedes-Benz S500, 1999 Mercedes-Benz S420, 1999 Mercedes-Benz S320, and 1999 Mercedes-Benz CL600. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Puller (001 589 50 33 00)

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

Fig 2: Identifying Clamping Pliers ((140 589 06 34 00)

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

Screw in clamping pliers in puller and tighten.
Position puller above bearing inner race.
Turning top part of puller counterclockwise (arrow) tightens clamping pliers (figure A).
Use puller to pull grooved ball bearing out of transmission housing (figure B).

Fig 3: Turning Top Part Of Puller Counterclockwise
Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

Fig 4: Pulling Grooved Ball Bearing Out Of Transmission Housing
Courtesy of MERCEDES-BENZ OF NORTH AMERICA.