Remove/install knock sensors - AR15.12-P-2184E
WARNING: This page does not describe the selected car, but rather 42 other vehicles, including the 1999 Mercedes-Benz S600, 1999 Mercedes-Benz S500, 1999 Mercedes-Benz S420, 1999 Mercedes-Benz S320, and 1999 Mercedes-Benz CL600. However, it is still accessible from the selected car via links, so may be relevant.
ENGINE 119.97
| Graphic-Item, etc. | Work instructions | ||
|---|---|---|---|
| Remove/install engine support | Refer to Repair manual Engine 119.960/970/971/972/974/975 Mechanic II Op-no..22-2500 | ||
| Clutch | Detach switching unit | ||
| Knock sensors | The lines of both knock sensors are joined together in a protective hose (shaft tube). They can only be replaced as one unit | ||
| Arrows | Bolts | *BA15.10-P-1001-02A |
| Number | Designation | Engine 112.910/911/912/ 913/914/915/ 916/917/920/ 921/922/923/ 940/941/942/ 943/944/945/ 946/947/949/ 951/953/954/ 955/960/961/ 970/972/973/975 | Engine 119, 120 | |
|---|---|---|---|---|
| BA15.10-P-1001-02A | Bolt securing knock sensor to cylinder block | Nm | 20 | 20 |