Pressing grooved ball bearing out and in at rubber mount of propeller shaft - AR41.10-P-0100-02DA

WARNING: This page does not describe the selected car, but rather 42 other vehicles, including the 1999 Mercedes-Benz S600, 1999 Mercedes-Benz S500, 1999 Mercedes-Benz S420, 1999 Mercedes-Benz S320, and 1999 Mercedes-Benz CL600. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Removal And Installation Tool (116 589 09 43 00)

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

Fig 2: Identifying Removal And Installation Tool (201 589 09 43 00)

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

Press out grooved ball bearing

Using the press out/in (tool 04), pry the grooved ball bearing (8) out of the rubber mount (7).
116 589 09 43 00 use with grooved ball bearing inside dia. of 30 mm.

201 589 09 43 00 use with grooved ball bearing inside dia. of 25mm.

Fig 3: Pressing Grooved Ball Bearing Out And In At Rubber Mount Of Propeller Shaft
Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

Press in grooved ball bearing

Press grooved ball bearing (8) into the rubberized bearing seat up to the contact surface (arrows) using removal tool and press-in tool (04).
Ensure that the grooved ball bearing (8) is properly seated.

Fig 4: Locating Contact Surface And Grooved Ball Bearing
Courtesy of MERCEDES-BENZ OF NORTH AMERICA.