Removing and Installing Air Cleaner - RA09001190015X(09-0015)
WARNING: This page does not describe the selected car, but rather 42 other vehicles, including the 1999 Mercedes-Benz S600, 1999 Mercedes-Benz S500, 1999 Mercedes-Benz S420, 1999 Mercedes-Benz S320, and 1999 Mercedes-Benz CL600. However, it is still accessible from the selected car via links, so may be relevant.
Operation no. of operation texts and work units or standard texts and flat rates:
09-0015
| Cover (1) | remove upward, insert. |
| Air intake hoses (2) | detach from air cleaner, fit on. |
| Crankcase ventilation hose (3) | detach, fit on. |
| Electric cable for electronic accelerator pedal at air cleaner | remove upward, insert from above. |
| Air cleaner (4) | pull up at the front, remove from mounting, insert. Then pull air cleaner forward out of rear mounting (5), insert (see note, step 2). Installation notes Install air cleaner housing so that the vacuum pipe of the brake servo unit runs over the air intake connection. Check clearance of cover (1) to brake vacuum pipe (arrow). Specify clearance 8 mm (see note, step 1). When installing the air cleaner, ensure the rubber seal between air cleaner and air flow sensor is in proper condition and properly seated; replace seal if necessary. |
Notes
- When installing the air cleaner (4), it is essential to ensure that the vacuum pipe of the brake servo unit (arrow) runs over the air intake hose (2).
- Since October 1989 the bearing bracket at the front for the air cleaner cover has been modified in shape in order to increase the clearance to the ignition cable duct.
PRODUCTION BREAKPOINT 10/89
| Model | Engine | Engine end no. |
|---|---|---|
| 129.066 | 119.960 | 002 294 |