Remove/install headlamp reflector - AR82.10-P-2850B
MODEL 129 except CODE (491) USA version with CODE (612) Xenon headlamp unit
| Remove/install | |||
| Risk of death
caused by high voltage levels present at xenon headlamps. Risk of explosion/fire hazard through highly flammable material in the area of damaged xenon bulbs. Risk of injury through UV light, hot components on xenon headlamps and glass splinters when xenon bulbs burst. Risk of poisoning through inhalation of mercury vapor and swallowing of or skin contact with toxic salts and mercury compounds. |
Do not come into contact with parts that are under high voltage. Persons with active electronic implants (e.g. heart pacemakers) must never work on xenon headlamps. Switch off complete lighting system. Wear insulating safety shoes, safety glasses and protective gloves. Remove highly inflammable materials from the hazard area. Ensure that the workplace is sufficiently ventilated. | AS82.10-Z-0001-01A | |
| 1 | Switch off ignition | ||
| 2 | Remove lamp unit | AR82.10-P-4730B | |
| 3 | Remove bulbs in lamp unit | AR82.10-P-1201D | |
| 4 | Remove lens on headlamp unit | AR82.10-P-1820A | |
| 5 | Unclip and remove headlamp reflector (1) (arrows) | ||
| 6 | Install in the reverse sequence | ||
| 7 | Set zero position of headlamps with HHT | ||
| 8 | Check and correct headlamp adjustment | AP82.10-P-8260A |