Sealing rail on hard top - AR77.50-P-4500A

MODEL 129 

Figure 1 

Fig 1: Locating Sealing Rail On Hard Top (1 Of 4)

Figure 2 

Fig 2: Locating Sealing Rail On Hard Top (2 Of 4)

Figure 3 

Fig 3: Locating Sealing Rail On Hard Top (3 Of 4)

Figure 4 

Fig 4: Locating Sealing Rail On Hard Top (4 Of 4)

	Inspecting
1	Unlock hard top and shim
2	Pull seal out of rail on side of hard top at top (figure 1, arrow)
3	Unscrew screws from rail (3 each)
4	Install long wedge between rail and hard top (figure 2, arrow))	Long wedge	Figure
5	Remove sealant from rail and hard top	Use naphtha.
6	Apply sealant to rail (figure 3, arrows)		*BR00.45-Z-1007-02A
N	Screw on rail
8	Insert seal into rail on left and right approx. 5 cm
9	Lock hard top
10	Moisten seal and install completely in rail	Use rubber assembly fluid.	*BR00.45-Z-1010-06A
11	Remove sealant coming out	Use naphtha.
12	Unlock hard top
13	Slightly pull seal out in corner area of hard top
14	Press sealant in between seal and hard top (figure 4, arrows)		*BR00.45-Z-1007-02A
15	Install seal and lock hard top
16	Remove sealant coming out	Use naphtha.

Fig 5: Identifying Long Wedge (115 589 03 59 00)