LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 1994 >> C220 >> Repair and Diagnosis >> External Pages >> Different car >> Section 80 (Climate Control - 140 Chassis) >> Repair & Adjustments >> Removing, installing and checking evaporator temperature sensor - ra83001400546x(0546)

Removing, installing and checking evaporator temperature sensor - ra83001400546x(0546)

WARNING: This page does not describe the selected car, but rather 42 other vehicles, including the 1999 Mercedes-Benz S600, 1999 Mercedes-Benz S500, 1999 Mercedes-Benz S420, 1999 Mercedes-Benz S320, and 1999 Mercedes-Benz CL600. However, it is still accessible from the selected car via links, so may be relevant.

Model 140 

Operation no. of job texts and work units, standard texts and flat rates: 83-6630

Fig 1: Identifying Evaporator Temperature Sensor And 2-Pole Connector
G05440918Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
Lower section of covering under left side of dashboard Remove (68-150) .
2-pole connector (B10/6x1) Disconnect.
Evaporator temperature sensor (B10/6) Pull out.
Temperature sensor Check and renew if necessary.
Install In the reverse sequence.
  IMPORTANT Erase fault memory in the control unit (Diagnosis manual - air conditioning).
TEST DATA

Sensor temperature in °C Resistance in kΩ
0 8.1-9.9
+5 6.3-7.7
+10 5.0-6.0
+15 4.0-4.6
+20 3.1-3.9
+25 2.4-3.0
+30 1.9-2.3
+35 1.6-2.0
+40 1.4-1.6
+45 1.1-1.3
COMMERCIALLY AVAILABLE

Multimeter e. g. Sun, DMM-5