Attaching Mercedes-Benz quick-clamping devices - AR40.20-P-0230A

WARNING: This page does not describe the selected car, but rather 42 other vehicles, including the 1999 Mercedes-Benz S600, 1999 Mercedes-Benz S500, 1999 Mercedes-Benz S420, 1999 Mercedes-Benz S320, and 1999 Mercedes-Benz CL600. However, it is still accessible from the selected car via links, so may be relevant.

MODEL 129, 140, 163, 170, 171, 202, 203, 208, 210

Fig 1: Identifying Mounting Holes In Disc Wheel - Model 129, 140, 170, 202, 203, 208, 210

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

Fig 2: Identifying Mounting Holes In Disc Wheel - Model 163

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

Fig 3: Identifying Mercedes-Benz Quick-Clamping Devices

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

Model 129, 140, 170, 202, 203, 208, 210

MODEL 163

	Installing, removing
1	Attach quick-clamping devices to front and rear axles and remove clamp handles	The mounting bell is centered on the front wheel hub or rear axle shaft flange by locating the tracer pins in the five mounting holes (arrows) in the rim. Check quick-clamping devices, wheel mirrors and measurement sensors at regular intervals in accordance with the manufacturer's instructions Quick-clamping device	Fig 4
2	Attach wheel mirrors or measurement sensors
3	Remove in reverse order

Fig 4: Identifying Quick Clamping Device (124 589 01 31 00)

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.