Remove/install thrust arm - AR35.20-P-0113A

WARNING: This page does not describe the selected car, but rather 42 other vehicles, including the 1999 Mercedes-Benz S600, 1999 Mercedes-Benz S500, 1999 Mercedes-Benz S420, 1999 Mercedes-Benz S320, and 1999 Mercedes-Benz CL600. However, it is still accessible from the selected car via links, so may be relevant.

MODEL 140

Fig 1: Identifying Thrust Arm Components

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

Figure item, etc.	Work instructions
	Risk of fatal accident from vehicle slipping or toppling off the lift platform	Align vehicle between the columns of the lifting platform and position the four support plates at the lifting platform support points specified by the vehicle manufacturer.	AS00.00-Z-0010-01A
5	Thrust arm	Installation: Replace self-locking nuts The rear axle shaft must be horizontal when tightening the nuts
		Thrust arm to wheel carrier	*BA35.20-P-1002-05A
		Thrust arm to rear axle carrier	*BA35.20-P-1001-05A
5c	Fitted bolt	Installation: install new fitted bolt
5 g	Thrust arm cover

THRUST ARM

Number	Designation			Model 140
BA35.20-P-1001-05A	Self-locking nut, thrust arm to rear axle carrier		Nm	70
BA35.20-P-1001-05A	Self-locking nut, thrust arm to rear axle carrier		∠°	-
BA35.20-P-1002-05A	Self-locking nut, thrust arm to wheel carrier	M10	Nm	-
		M12	Nm	70
			∠°	-