Removal and installation of rear rubber mounts of rear axle suspension - AR35.10-P-0040-03B
WARNING: This page does not describe the selected car, but rather 42 other vehicles, including the 1999 Mercedes-Benz S600, 1999 Mercedes-Benz S500, 1999 Mercedes-Benz S420, 1999 Mercedes-Benz S320, and 1999 Mercedes-Benz CL600. However, it is still accessible from the selected car via links, so may be relevant.
REPAIR MATERIALS
| Number | Designation | Order number |
|---|---|---|
| BR00.45-Z-1002-06A | Lubricant | A 000 989 01 60 |
Removal of rubber mount
- Place extractors (01l, 01m, 01n) on rear axle carrier.
The arrow (refer to detail) of the upper side of the extractor cone must point in the direction of travel.
- Press rubber mount (1b) out of the rear axle carrier.
Installation of rubber mount
- Pull-in tool, 2nd version with extended internal thread of the pull-in plate (01o) and shortened hexagon bolt (01r)
- 3.1 Coat circumference of rubber mount (1b) with lubricant.
- 4.1 Mount pull-in tool (01o - 01r) on rear axle carrier.
- 5.1 Pull rubber mount into the rear axle carrier.
- Pull-in tool, 1st version without extended internal thread of the pull-in plate (01h) and shortened hexagon bolt
- 3.2 Coat circumference of rubber mount (1b) with lubricant.
- 4.2 Mount pull-in tool (01h, 01p) on rear axle carrier.
- 5.2 Pull in rubber mount until the thread of hexagon bolt abuts the threaded bolt of the frame floor.
- 6.2 Place washers (B12) with a height of approx. 30 mm on the hexagon bolt and pull in rubber mount until it fits closely against the rear axle carrier.