Remove/install camber strut - AR35.20-P-0110A: Notes
WARNING: This page does not describe the selected car, but rather 42 other vehicles, including the 1999 Mercedes-Benz S600, 1999 Mercedes-Benz S500, 1999 Mercedes-Benz S420, 1999 Mercedes-Benz S320, and 1999 Mercedes-Benz CL600. However, it is still accessible from the selected car via links, so may be relevant.
MODEL 140
| Figure item, etc. | Work instructions | ||
|---|---|---|---|
| Lethal injuries are possible if vehicle slips off of lifting platform | Align vehicle between the four pillars of the hoist and position the four support plates at the hoist mounting points specified by the vehicle manufacturer. | AS00.00-Z-0010-01A | |
| Replace self-locking nuts and bolts | |||
| Spring link covering | remove | ||
| 1c | Front bolt, rear axle mount | ||
| *BA35.10-P-1001-01A | |||
| Rear axle mounting bolt | |||
| *BA35.10-P-1002-01A | |||
| 2 | Camber strut | ||
| *BA35.20-P-1002-02A | |||
| *BA35.20-P-1001-02A | |||
| 2a | Removal and insertion of attachment bolt, camber strut on rear axle carrier | AR35.20-P-0110-01A | |
| 2 C | Fitted bolt | ||
| 6j | Remove shock absorbers/struts | at track control arm | |
| *BA32.25-P-1002-03B | |||
| *BA32.30-P-1002-01A | |||
| 6p | Compressing, releasing rear spring | AR32.20-P-0200-01A |
| Number | Designation | Model 140 | |
|---|---|---|---|
| BA32.25-P-1002-03B | Self-locking nut for attaching shock absorber to spring link | Nm | 100 |
| Number | Designation | Model Series 140 with ride-height control/ADS | |
|---|---|---|---|
| BA32.30-P-1002-01A | Self-locking nut, level control / ADS spring strut to spring link | Nm | 100 |
| Number | Designation | Model 140 | |||
|---|---|---|---|---|---|
| BA35.10-P-1001-01A | Self-locking bolt of front rubber mount on rear axle carrier to frame floor | Nm | 70 | ||
| with bolt | 1st stage | Nm | - | ||
| flange ø 24 mm | 2nd stage | ∠° | - | ||
| with bolt | 1st stage | Nm | - | ||
| Flange ø 26mm | 2nd stage | ∠° | - | ||
| BA35.10-P-1002-01A | Self-locking bolt, rear axle carrier rear rubber mount to frame floor | Nm | 70 | ||
| with bolt | 1st stage | Nm | - | ||
| flange ø 24 mm | 2nd stage | ∠° | - | ||
| with bolt | 1st stage | Nm | - | ||
| Flange ø 26mm | 2nd stage | ∠° | - | ||
| Number | Designation | Model 140 | ||
|---|---|---|---|---|
| BA35.20-P-1001-02A | Self-locking nut, camber strut to rear axle carrier. | 1st stage | Nm | 70 |
| 2nd stage | ∠° | - | ||
| BA35.20-P-1002-02A | Self-locking nut, camber strut to wheel carrier. | M10 | Nm | - |
| M12 | Nm | 70 | ||