Pulling tapered roller bearing inner race off drive pinion - AR35.31-P-0550-10A

WARNING: This page does not describe the selected car, but rather 42 other vehicles, including the 1999 Mercedes-Benz S600, 1999 Mercedes-Benz S500, 1999 Mercedes-Benz S420, 1999 Mercedes-Benz S320, and 1999 Mercedes-Benz CL600. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Puller (001 589 50 33 00)

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

Fig 2: Identifying Extension (000 589 63 34 00)

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

Fig 3: Identifying Collet Chuck (000 589 02 34 00)

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

Fig 4: Identifying Open-End Wrench (140 589 00 01 00)

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

Assemble puller (024) with extension (024c) and clamping pliers (024a) and tighten.
Use an open wrench if necessary to assemble and disassemble the extension (024c).

Fig 5: Identifying Clamping Pliers, Extension And Puller
Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
Push puller (024) with clamping pliers (024a) above the tapered roller bearing inner race and clamp securely behind the rollers (arrow) using a roll pin (024b).
Using the puller (024), detach the tapered roller bearing inner race from the drive pinion (47) and remove.

Fig 6: Pulling Tapered Roller Bearing Inner Race Off Drive Pinion
Courtesy of MERCEDES-BENZ OF NORTH AMERICA.