LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 1994 >> C220 >> Repair and Diagnosis >> External Pages >> Different car >> Section 72 (Rear Axle - 140 Chassis) >> Testing & Repair >> Disassembling and assembling rear axle, adjusting gear set - AR35.31-P-0550 >> Disassemble/assemble rear axle center assembly, adjusting gear set - AR35.31-P-0550D >> Pulling off joint flange - AR35.31-P-0550-06B

Pulling off joint flange - AR35.31-P-0550-06B

WARNING: This page does not describe the selected car, but rather 42 other vehicles, including the 1999 Mercedes-Benz S600, 1999 Mercedes-Benz S500, 1999 Mercedes-Benz S420, 1999 Mercedes-Benz S320, and 1999 Mercedes-Benz CL600. However, it is still accessible from the selected car via links, so may be relevant.
REFER TO COMPONENT MODIFICATIONS Radial seal ring and joint flange on drive pinion modified Rear axle center assembly with 185 mm, 210 mm dia. ring 01.04.98 BT35.31-P-0012-01A 
Fig 1: Identifying Puller (129 589 01 33 00)
G04636415Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
    1. If necessary, mark joint flange relative to drive pinion.
  2. Pull joint flange off drive pinion, use puller SPECIAL TOOL (062) if necessary.

    Shown: 168 mm dia. rear axle center assembly 

    Fig 2: Pulling Joint Flange Off Drive Pinion - Shown On 168 mm Dia. Rear Axle Center Assembly
    G04636416Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
scientia non olet · About LEMON Manuals