Authorization for taxi emergency call - AR82.95-P-0012A

WARNING: This page does not describe the selected car, but rather 42 other vehicles, including the 1999 Mercedes-Benz S600, 1999 Mercedes-Benz S500, 1999 Mercedes-Benz S420, 1999 Mercedes-Benz S320, and 1999 Mercedes-Benz CL600. However, it is still accessible from the selected car via links, so may be relevant.

MODEL 140, 202, 210, 220 with CODE (930) Taxi emergency call with CODE (934) Taxi emergency alarm unit with SIM card from debitel for D1 GSM network

	Notes regarding the taxi emergency call system	Models 140, 202, 210, 220 with SIM card from debitel for the D1 GSM network	AH82.95-P-0002-01A
1	Program transmitters for emergency alarm remote control actuation	The transmitters for the emergency alarm radio remote actuation (A8/4) should be programmed to the vehicle, if not, perform programming.
	Transmitter for emergency alarm remote control actuation, purpose		GF82.25-P-4105-01S
2	Connect hand-held tester (HHT) to diagnostic connector and select corresponding vehicle
3	Select "EIS version coding"
4	Read/change EIS coding Select "08 MSS version, taxi with emergency alarm/call"
5	MSS version coding Select "4 taxi emergency alarm and call"
6	MSS version coding Select "1 silent alarm"
7	MSS control module adaptations Set "02 radio system" to "YES"	The radio system should be activated so that the "emergency call" can be actuated with the emergency alarm actuation button (S62/6).
8	MSS version coding Select "3 radio remote control actuation"
9	MSS control module adaptations Set "04 taxi radio system" to "YES" "05 taxi emergency call" to "YES"
10	Perform TELE AID authorization	The taxi emergency call authorization and check is the first priority in the TELE AID system. Refer to: ↓
	Perform authorization for TELE AID	MODELS 129, 140, 170, 202, 208, 210, 220 with SIM card from debitel for the D1 GSM network	AR82.95-P-0011A
11	Trigger taxi emergency call	The Tegaron contact person gives instructions for the following steps for the function check. No voice link is established in the case of taxi emergency call; the control center listens into the vehicle. The location of the individual components is described in the following documents.
	TELE AID, location of components	Model 140 except 140.063/07	GF82.95-P-0001-01A
		Model 140.063/07	GF82.95-P-0001-01C
		Model 202	GF82.95-P-0001-01F
		Model 210 except 210.2	GF82.95-P-0001-01B
		Model 210.2	GF82.95-P-0001-01D
	Emergency alarm system, location of components	Models 202, 210 except 210.081, 210.281 as of production period 1.3.97	GF82.25-P-0003-01A
12	Actuate emergency alarm actuation button (S62/6) twice within 3 s	Tegaron confirms receipt of "emergency call". Otherwise contact Tegaron.
13	Actuate transmitter 1 for emergency alarm radio remote actuation (A8/4) twice within 3 s.	Tegaron confirms receipt of "emergency call". Otherwise contact Tegaron.
14	Actuate transmitter 2 for emergency alarm radio remote actuation (A8/4) twice within 3 s.	Tegaron confirms the receipt of the taxi emergency call. Otherwise contact Tegaron. Two transmitters are normally supplied. The transmitters may be extended arbitrarily. In this case, all transmitters must be tested.
15	Wait for fax answer from Tegaron	Tegaron confirms in writing the parameters of transmission and simultaneously the authorization of the vehicle. Contact Tegaron, if fax answer is not received.