LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 1994 >> C220 >> Repair and Diagnosis >> External Pages >> Different car >> Section 69 (Interior Equipment - 140 Chassis) >> Testing & Repair >> Cutting switch openings in cover - AR68.20-P-2030A >> Milling switch opening - AR68.20-P-2030-01B

Milling switch opening - AR68.20-P-2030-01B

WARNING: This page does not describe the selected car, but rather 42 other vehicles, including the 1999 Mercedes-Benz S600, 1999 Mercedes-Benz S500, 1999 Mercedes-Benz S420, 1999 Mercedes-Benz S320, and 1999 Mercedes-Benz CL600. However, it is still accessible from the selected car via links, so may be relevant.
Commercially available tools

Number Designation
WH58.30-Z-1011-20A Universal profile milling machine with surface milling cutter
(3 single lip miller ø 5x60mm, 2 single lip miller ø 5x90mm, templates, fixing supports for model 129, 170, 202, 208, 210, 463), Firma Fetzer GmbH 75446 Wiernsheim-Pinache
  1. Set turntable depth stop (7) on manual router to light colored stop screw (20).

    IMPORTANT Higher set light colored stop screw (20) for cover with aluminum plate and plastic reinforcement.

    IMPORTANT Lower set light colored stop screw (24)for wooden cover.

    NOTES Never readjust the stop screws which are permanently set by the manufacturer, because otherwise the mount would be damaged during operation.

    Fig 1: Identifying Turntable Depth Stop And Light Colored Stop Screw
    G04632590Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
  2. Switch on manual router and press down on both handles to stop. Tighten handle.
  3. Smoothly guide manual router in clockwise direction (direction of arrow) along light colored duplicating template on surface of mounting and clamping device. Loosen handle.
  4. Switch off manual router.
    Fig 2: Guiding Manual Router In Clockwise Direction
    G04632591Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
scientia non olet · About LEMON Manuals