LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 1994 >> C220 >> Repair and Diagnosis >> External Pages >> Different car >> Section 62 (Automatic Transmission - 140 Chassis) >> Testing & Repair >> Checking oil level in automatic transmission and correcting, if necessary - AR27.00-P-0100A

Checking oil level in automatic transmission and correcting, if necessary - AR27.00-P-0100A

WARNING: This page does not describe the selected car, but rather 42 other vehicles, including the 1999 Mercedes-Benz S600, 1999 Mercedes-Benz S500, 1999 Mercedes-Benz S420, 1999 Mercedes-Benz S320, and 1999 Mercedes-Benz CL600. However, it is still accessible from the selected car via links, so may be relevant.

TRANSMISSION 722.3/4/5 

Fig 1: Checking Oil Level In Automatic Transmission
G04715335Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
Fig 2: Identifying Oil Level
G04715336Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
INSPECT Checking    
IMPORTANT Park vehicle on a level surface to check the oil level    
1 Check transmission for leaks before checking the oil level. If oil loss is severe, determine and eliminate cause  
DANGER Risk of accident  as a result of vehicle starting off when engine running. Risk of injury  as a result of bruises and burns if you insert your hands into engine when it is being started or when it is running. Secure vehicle to prevent it starting off.
Wear closed and close-fitting work clothes.
Do not grasp hot or rotating parts.
AS00.00-Z-0005-01A
2 Allow engine to run    
3.1 Open locking lever (6a) IMPORTANT Up to 09/93 (Fig 1 )  
3.2 Press locking pin (6b) to one side in direction of the arrow, remove both parts and open locking lever (6a) IMPORTANT As of 10/93 (Fig 1 )  
4 Pull out oil dipstick (6) Wipe with fluff-free cloth  
5 Insert oil dipstick (6) up to the stop, pull out again and read off oil level When the transmission is cold (transmission oil temperature approx. 30°C) the display must be between the "min." and "max." marks for the correct oil level (Fig 2 ).
When the transmission is at operating temperature (transmission oil temperature approx. 80°C) the display must be at the "max." mark for the correct oil level (Fig 2 ).
 
  Correcting     
6 Pour in transmission oil when engine is running SPECIAL TOOL Fig 3
    SPECIAL TOOL
NOTES Excess transmission oil must be drained or extracted
An insufficient or excessive quantity of oil impairs the operation of the transmission.
FLUID SPECIFICATION Automatic transmission fluid in accordance with Specifications for Service Products, sheet 236.4/6/7
Fig 4
7 Check oil level once again Correct, if necessary  
8 Close locking lever (6a) IMPORTANT Up to 09/93 (Fig 1 )  
9 Close locking lever (6a) and insert locking pin (6b) until it engages IMPORTANT As of 10/93 (Fig 1 ) Insert oil dipstick (6) so that the locking clip (6a) is easily accessible and does not make contact anywhere.  
Fig 3: Identifying Funnel (126 589 12 63 00)
G04715337Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
Fig 4: Identifying Hand Pump (210 589 00 71 00)
G04715338Courtesy of MERCEDES-BENZ OF NORTH AMERICA.